Kermi Casteo bathroom radiator 60 x 3 x 125.9 cm

Properties:

• Compact radiator for hot water operation
• with horizontal flat pipes 7.7 x 1 cm and U-shaped frame made of square profiles 3 x 2.8 cm
• without visible weld seams
• large distances between the pipes for towel hanging
• the fixing is made on the back of the collecting pipes
• the enclosed fixing set complies with VDI 6036 requirement class 2; Requirement class 3 possible on request
• easy-to-install fastening, not visible from the front
• the wall-building material must be checked on site for sufficient load-bearing capacity
• horizontal, vertical and wall-spaced alignment possible
• visible parts of the accessories in radiator colour
• paint

finish:Two-coat paint according to. DIN 55900, primer (ETL), powder coating (EPS), emission-free even in heating mode
Packed ready for assembly in cardboard box and shrink-wrapped in foil
Tested according to DIN EN 442
Awarded the RAL quality mark
Operating pressure: max. 4 bar (test pressure: 5.2 bar)
Operating conditions: Hot water up to 110° C
suitable for single-pipe operation
Connections:

2x G 1/2" internal thread centrally downwards, hub spacing 5 cm, flow left or right possible
additionally laterally 2 x G 1/2" internal thread downwards, hub spacing dependent on construction length, flow left or right possible
Venting: G 1/4" internal thread to the rear, left
Connection to Kermi x-net underfloor heating possible via x-link plus connection set
Heat output according to DIN EN442:

• at (75/65/20): 638 watts
• at (70/55/20): 520 watts
• at (55/45/20): 342 wat

ts
Please order valve set and thermostatic head separately

Optional additional electric operation is possible (max. flow temperature 80° C). The electric set with matching wattage can be found in the accessories.
The following notes on installation: When connecting the heating flow and return to the centre connection, the electric heating element can be installed in the right or left manifold without restriction.
When installing the electric heating element in the heating flow or return, a T-piece is mandatory (connections: 2x G½" IT, 1x G½" ET). This changes the position of the pipe to the radiator! For this reason, an electric heating rod cannot be retrofitted here after the radiator has already been installed.